-
Frame is built from 3x2, 2x2, & 4x2 11-gage tubing all mig welded.
-
All open-end tubes are steel capped, welded, and ground smooth.
-
Base 4x2 tubes are cut at a 45 degree and ¼”x2x4 floor mount plates with ½” hole are welded to the end.
-
Backrest pad assembly is adjustable from 0-45 degree.
-
(2) Hydraulic cylinders are mounted from base and upper frame to assist back pad angle adjustment.
-
Upper pad assembly has adjustable foot catch consisting of a set of round rollers accepted by a pop pin.
-
Foot catch calf pad is elevated 12” above back pad to relax hip erectors from the crunch movement.
-
Under foot catch leg pad are mounted a pair of foam covered multi grip handles to perform roll ups for lower ABS.
-
Mid pad on the adjustable back pad, is mounted to the frame a pair of adjustable armrest pads.
-
Armrest pads adjust in & out in with and move on a chrome 2”x 2” slide assembly.
-
Grip handles adjust to length of the users forearm, handles point forward at 60 degrees toward the inside of the bench. Elbow pads are a 6”x 12” contoured pad, which are covered in a double wrap. All movable parts use a tightener knob to secure part from wobble.
-
Dimensions are W39" x L56" x H50” Weight 150 lb.
